For straight, non-loadbearing internal partitions. For tall, curved, fire-rated or other specialist walls, consult a qualified professional and the complete manufacturer’s system specification.

01

Wall dimensions

Enter the finished wall size in millimetres.

Faces to board
02

Metal frame

Profile depth, stud centres and stock lengths.

Use compatible C studs and U channels from one system; actual channel width can differ from stud depth.

03

Plasterboard

Choose layers and the sheets you will buy.

Layout drawing

Frame and board layers

The drawing shows one face; buying quantities include both faces if selected.

Frame and board layersThe drawing shows one face; buying quantities include both faces if selected.
✓

Materials shopping list

Plasterboard sheets in cutting plan
Vertical studs
U channels
Nominal wall thickness
Materials shopping list

Main materials

Materials shopping list

Fixings and jointing

How to use this calculator

Installation checks

From measurements to materials

How to use this calculator

Measure the wall, choose compatible frame and sheet sizes, then review the layout and shopping list. Check your chosen system before ordering.

01

Measure the partition

Enter finished width and height, then choose one or both boarded faces. Add a door only if its opening and position are known.

02

Specify the metal frame

Choose a compatible C-stud and U-channel system, stud centres and stock lengths that your merchant actually sells.

03

Choose the plasterboard

Set the sheet width, length, thickness and one or two layers per face. Short sheets may need supported horizontal joints.

04

Review the plan

Switch between frame and board views. Check the cutting plan, optional spare and system details before ordering.

C studs, U channels and reinforced jambs

C studs form the uprights, while U channels form the floor and ceiling tracks. Their nominal dimensions need not be identical: buy sections specified together as a complete system.

A door opening may require reinforced jamb studs and matching brackets. The correct detail depends on door weight and the system supplier, not just the wall width.

Why stagger plasterboard joints?

On a two-layer lining, the outer boards start on different supported studs so their vertical joints do not align with the inner layer. Joints on the opposite face should also be offset.

Fill inner-layer joints where the manufacturer requires it before fixing the outer layer. Finish exposed joints with compatible compound and tape.

How the shopping quantities are calculated

The cutting plan packs stud and channel sections into the selected stock lengths and reuses suitable offcuts. Board offcuts can be used across layers and faces when their dimensions fit.

The bold sheet count is the planned minimum. A spare appears separately only when the usable cutting margin is tight; door cut-outs are not assumed reusable.

When you need a system design

This estimate does not establish a fire or acoustic rating, permissible wall height or structural support. Tall, wet-area, heavily loaded or separating walls need the manufacturer’s complete tested system and professional review.

Plan additional backing for heavy cabinets, sanitaryware or screens. Those supports are not included in this material list.

i

Technical reference

Indicative material estimate, not a tested partition design. Verify all details with the system manufacturer.

Frequently asked questions

Practical answers before buying materials.

Yes. Boards and screws are counted for the chosen face; frame and cavity insulation remain unchanged. An open frame is not a tested acoustic or fire-rated partition.
The cutting plan reuses suitable sheet and profile offcuts. Door cut-outs are not assumed reusable. A spare sheet is shown separately only if the cutting margin is small.
For two layers, offset joints between layers and opposite faces. Fill inner-layer joints where required by the selected system.
No. Confirm height limits, stud centres, openings, fire and acoustic performance with a qualified professional and the complete system documentation.
Support boards on temporary packers and leave the floor clearance specified by the chosen system. Do not press the board edge directly onto the floor or fill a movement gap with rigid material.
This calculator assumes full-length uprights and rejects a stock length that is too short. Only splice studs if the particular tested system expressly permits its joint and overlap detail.